Home › Burst pipe: what to do in the first ten minutes
Guide · Yarragon plumbing

Burst pipe: what to do in the first ten minutes

A plain guide for Yarragon homes and farms. Turn the water off, make it safe, then ring 03 8658 7871.

Prefer email? info@yarragonplumbing.com.au

  • Local to Yarragon
  • Licensed and insured
  • Quote before work
  • Same-day where we can

Minute one: stop the water

Go straight to the water meter. In Yarragon township it is normally in a small box or pit near the front boundary, often close to the letterbox or the side fence. Lift the lid, find the tap on the meter and turn it clockwise until it stops. If the tap is stiff, use gentle steady pressure rather than a hammer, because old meter taps can snap.

On tank water, switch off the pressure pump at its power point. If you can safely reach it, close the valve at the tank outlet as well. Do not leave the pump running with a burst line, because it will empty the tank and can burn itself out.

Minute two: think about power

If water is running near power points, light fittings or the switchboard, keep away from it. If you can reach the main switch from dry ground, turn the power off. If not, leave it and tell us when you ring.

Minutes three to five: ring and protect

Ring 03 8658 7871. Tell us where the water is coming from, what you have turned off and how to find the property. Then move furniture, rugs and electrical items away from the water, put towels down and catch drips with buckets. If a ceiling is bulging with water, keep everyone out from under it.

Minutes five to ten: take photos

Before you start cleaning up, take photos of the burst, the water and any damage. Insurers usually want to see them, and they help us understand what happened.

While you wait

Open the lowest tap in the house to drain the remaining water from the pipes. If the burst is on the hot side, turn off the hot water unit at the switchboard or the gas control, so it does not heat an empty tank. Keep children and pets away from wet floors.

What not to do

Do not wrap tape around a spraying pipe and turn the water back on. Do not try to solder or glue a pipe with water still in it. Do not use electrical appliances to dry a wet floor until the power is confirmed safe.

Why knowing your meter matters

Many people only look for their meter for the first time in the middle of a burst. Take two minutes this weekend to find yours, check the tap turns, and show everyone in the house. On a farm, find the tank outlet valve and the pump switch too. It is the best plumbing preparation you can do.

Read before you ring

More guides

Plumbing checks before you buy an older homeWhat to check in the plumbing before buying an older Yarragon home or rural property: pipes, sewer, hot water, gas, tanks and septic.Choosing a hot water system for a Gippsland homeGas, electric, solar, heat pump or continuous flow? A plain comparison for Yarragon and Gippsland homes, including LPG and tank-water properties.Finding and reading your water meter in YarragonHow to find and read your water meter in Yarragon, test for hidden leaks, and where the shut-off points are on tank-water properties.Protecting your pipes from frostHow to protect exposed water pipes, garden taps, tank lines and hot water units from frost on cold Yarragon and Gippsland mornings.Getting your gas heater ready for winterGetting gas heaters ready for a Gippsland winter: servicing, carbon monoxide warning signs, ventilation and LPG bottle checks.How to choose a plumber in YarragonWhat to look for when choosing a plumber in Yarragon: licences, insurance, compliance certificates, clear quotes and local knowledge.No hot water? A safe checklist before you ringWoke up to a cold shower in Yarragon? Safe checks for electric, gas, LPG, solar and continuous flow hot water before you ring a plumber.Looking after a septic system on a Baw Baw propertyHow to look after a septic tank and trenches on a rural property near Yarragon: what to flush, when to pump out and the warning signs.Keeping your tank water cleanPractical steps to keep tank water clean on Yarragon and Gippsland properties: gutters, first-flush diverters, filters, sludge and what to do if water smells.Tree roots and old clay sewers: what Yarragon owners should knowWhy roots get into old earthenware sewer pipes in Yarragon, the warning signs, and the choice between clearing, relining and replacing.
Free quote

Tell us about the job

Tell us what is happening and a licensed Yarragon plumber will ring you back. If water is pouring out or you can smell gas, call 03 8658 7871 instead.

03 8658 7871

We quote every job individually. We do not publish price lists, because the right answer depends on what we find.







    Need a plumber in Yarragon today?

    Talk to a licensed plumber, not a call centre. Quote first, then the work.