Hot Water Repairs Yarragon
No hot water, a shower that runs cold halfway through, or water pooling under the unit? Our Yarragon plumbers repair gas, electric, solar and heat pump hot water systems. Ring 03 8658 7871.
Prefer email? info@yarragonplumbing.com.au
- Local to Yarragon
- Licensed and insured
- Quote before work
- Same-day where we can

Hot water problems we fix
Hot water faults tend to show up at the worst possible moment, usually on a cold Gippsland morning. The most common calls we get are:
- no hot water at all
- water that is warm but never properly hot
- hot water that runs out much faster than it used to
- water leaking from the base of the unit or dripping from a valve
- a relief valve that is constantly running or spitting
- a gas unit with a pilot light that will not stay lit
- noisy units that rumble, bang or hiss
- discoloured or smelly hot water
Most of these can be diagnosed in one visit, and many can be fixed on the spot with parts we carry in the ute.
Types of hot water systems in Yarragon homes
Gas storage
A tank of water heated by a gas burner underneath. Common in older homes on natural gas and on rural properties using LPG bottles. Faults usually involve the thermocouple, pilot assembly, gas control valve or the tank itself.
Electric storage
A tank heated by one or two electric elements, often on an off-peak tariff. Faults include failed elements, thermostats, wiring problems and tank leaks. Many older Yarragon houses still have an electric storage unit in the laundry or outside on the wall.
Continuous flow (instantaneous)
Gas units that heat water only as you use it. They are compact and never run out, but they need adequate gas supply and good water flow. Faults include ignition problems, flow sensors, scale build-up and error codes.
Solar
Roof collectors heat water that is stored in a tank, usually with a gas or electric booster for cloudy days. Problems include failed pumps, leaking collectors, booster faults and valve issues.
Heat pump
These work like a fridge in reverse, pulling heat out of the air. They are efficient but have more components to go wrong, including fans, compressors and sensors. They also need a little clearance around them to breathe.
We service and repair all of these types. If a part is no longer made for an older unit, we will tell you and talk through the options.
Common causes and what we do about them
No hot water on a gas unit
The pilot light may have gone out because of a draught, a failing thermocouple or a dirty pilot. We clean, test and replace parts as needed. If the gas control valve has failed, we can usually replace it, though on an old unit replacement of the whole heater can sometimes make more sense.
No hot water on an electric unit
A tripped circuit breaker, a burnt-out element or a failed thermostat are the usual causes. We test the element and thermostat and replace whichever has failed. If the breaker keeps tripping, there may be water getting into the electrical compartment, which points to a leak.
Lukewarm water
A tempering valve that has failed is a very common cause. These valves blend hot and cold water to a safe temperature for bathrooms, and when they wear out the water can be too cool. Other causes include a failed element, a thermostat set too low, a broken dip tube, or a booster that is not kicking in on a solar system.
Running out of hot water
Sediment build-up in the bottom of the tank reduces how much hot water it can hold. A failed lower element on a twin-element electric unit has the same effect. Sometimes the system is simply too small for the household, especially after more people move in.
Leaks
A drip from the relief valve can be normal while the unit heats, but constant flow is not. The valve may need replacing, or the water pressure may be too high and need a pressure limiting valve. A leak from the tank itself, especially from the base, usually means the tank has corroded through and cannot be repaired.
Rumbling or banging
Sediment in the base of the tank can cause rumbling as the water heats. On older homes with high mains pressure or loose pipes, water hammer can cause banging when taps are turned off. We can flush units, fit pressure limiting valves and secure loose pipes.
The anode: the part most people never hear about
Every storage hot water tank has a sacrificial anode, a metal rod that corrodes so the tank does not. Once the anode is used up, the tank starts to rust. Yarragon's water quality varies between town water and tank water, and anodes can wear out faster on some properties than others. Checking and replacing the anode every few years can add years to a tank's life. We are happy to do this as part of a service.
Repair or replace?
We always look at repair first. A new thermocouple, element, thermostat or valve can give an older unit years more life. But there are times when replacement makes more sense:
- the tank itself is leaking
- the unit is past its expected life and parts are scarce
- the repair would cost a large share of what a new unit costs
- the household needs a bigger system
- you want to move to a cheaper-to-run type of heater
If replacement makes sense, we explain the options and give you a written quote before doing anything. See our hot water replacement page for more detail.
Hot water on tank-water properties
On farms and lifestyle blocks running on rainwater, hot water systems can be affected by low pump pressure, sediment and debris from the tank, and changes in water chemistry. Strainers clog, valves stick and anodes behave differently. We check the whole supply when we look at a hot water problem on these properties, including the pump, filters and pressure.
Safety and the law
Victorian rules require hot water delivered to bathroom fixtures in new and replaced systems to be limited to a safe temperature, usually using a tempering valve. Storage water must still be heated hot enough inside the tank to control bacteria. We set up systems to meet both requirements, and we lodge compliance certificates where they are required.
Never try to adjust gas controls or open the electrical compartment of a hot water unit yourself. If the unit is leaking near the power, switch it off at the switchboard and call us.
Book a hot water repair
Ring 03 8658 7871 or send the form below. If you can, tell us the make and model of your unit, and send a photo of the label. That helps us bring the right parts and often means we can fix it on the first visit.
A few checks before you ring
Some hot water problems have simple causes you can check yourself, safely, before booking a visit:
- Electric units: check the switchboard. If the hot water circuit breaker has tripped, you can reset it once. If it trips again, leave it off and call us, because something is wrong.
- Off-peak units: if the water ran out after heavy use, the unit may simply need the overnight off-peak period to reheat.
- Gas units: check that the gas is on at the meter and, on LPG, that the bottles are not empty and the changeover valve has switched over.
- Solar units: on a run of cloudy days, check that the booster is switched on.
- Continuous flow units: note any error code on the controller. It helps us diagnose the fault.
Never remove covers, adjust gas controls or touch electrical parts. If none of these simple checks solves it, ring us.
A typical hot water call
A couple in a weatherboard near the main street ring on a Monday morning. The shower has been getting cooler for weeks, and today it was cold. Their electric storage unit sits outside on the side wall. We check the switchboard and the power to the unit, then test the elements and thermostats. The bottom element has burnt out and the top one has been doing all the work, which is why the hot water has been running out faster and faster. The tempering valve is also tired.
We replace the element and the tempering valve, check the anode while the unit is drained, and find it nearly used up. With the couple's go-ahead, a new anode goes in too. The unit is refilled, reheated and tested. They get hot water again by lunchtime, and a tank that should last several more years.
Tank water and your hot water unit
On rural properties around Yarragon, rainwater can be soft and slightly acidic, and tanks can deliver fine sediment. Both can affect a hot water system. Soft water can wear anodes faster than town water, and sediment can collect in the bottom of storage tanks and in the inlet strainers of continuous flow units. If you are on tank water, we recommend a sediment filter on the supply and more regular anode checks. It is a small cost compared to replacing a tank that rusted out early.
Tell us about the job
Tell us what is happening and a licensed Yarragon plumber will ring you back. If water is pouring out or you can smell gas, call 03 8658 7871 instead.
We quote every job individually. We do not publish price lists, because the right answer depends on what we find.
Hot Water Repairs: common questions
What is the legal temperature for hot water in Australia?
For new and replaced systems, hot water delivered to bathrooms and ensuites is generally limited to 50 degrees Celsius, usually with a tempering valve. Stored water in the tank must be kept hotter, typically at least 60 degrees, to control bacteria. We set systems up to meet the Victorian requirements.
Why is my hot water not coming out hot enough?
The most common causes are a worn tempering valve, a failed heating element or thermostat, a pilot or burner problem on a gas unit, sediment in the tank, or a booster that is not working on a solar system. We test each part to find the actual cause rather than guessing.
Why do plumbers not recommend tankless water heaters?
Continuous flow units suit many homes, but not all. They need enough gas supply and good water flow, older pipework can cause issues, and some households find the short wait for hot water annoying. We look at your gas supply, usage and pipework before recommending one.
How often should a hot water system be serviced?
Most manufacturers recommend a check every few years, including the relief valve and the anode in storage tanks. On tank-water properties or with hard water, more frequent checks can extend the life of the unit.
Is water dripping from my hot water unit normal?
A small amount of water from the relief valve while the unit heats can be normal. Constant flow, or water leaking from the tank or fittings, is not. Turn off the unit and the cold water valve, and ring us for a check.
What comes with hot water repairs from us
- Tools on the ute
- Drain camera and locator, electric drain machine, high-pressure jetter, thermal camera, acoustic leak gear, gas detector and pressure test kits
- Licences
- Victorian plumbing licences covering water supply, sanitary, drainage, roofing and gasfitting work
- Pricing
- A clear price agreed before work starts, and written quotes for bigger jobs. No call-centre surprises
- Materials
- WaterMark-certified products and fittings to Australian Standards
- Paperwork
- Compliance certificates lodged for regulated work, photos and notes for insurance where useful
- Clean-up
- Old parts taken away, floors and paths cleaned, the job tested with you before we go
Plain dealing, careful work
Weatherboards from the early 1900s, 1970s brick veneers, new homes on the edge of town and farmhouses on tank water: that is the mix we work on around Yarragon every week.
No surprises. The plumber diagnoses first and agrees the job and the price with you before picking up a tool.
Drain cameras, thermal imaging and acoustic gear show us where the problem really is, so we are not digging up your yard on a guess.
Water, sanitary, drainage, roofing and gasfitting work done by licensed plumbers, with compliance certificates where they are required.
Worth reading first
More plumbing services around Yarragon
- Emergency Plumber
- Blocked Drains
- Gas Plumber
- Hot Water Replacement
- Rainwater Tanks and Pumps
- Septic Plumbing
- Leaking Tap Repairs
- Burst Pipe Repairs
- Toilet Repairs
- Leak Detection
- Drain Camera and Pipe Relining
- Stormwater and Drainage
- Bathroom and Kitchen Plumbing
- Roof and Gutter Plumbing
- Backflow Testing and Commercial Plumbing
Towns we cover from Yarragon
We are based in Yarragon and work the Princes Highway towns either side, the hill country to the south and the farms out towards Shady Creek. If your place is not listed, ring 03 8658 7871 and ask.
Need a plumber in Yarragon today?
Talk to a licensed plumber, not a call centre. Quote first, then the work.