Home › No hot water? A safe checklist before you ring
Guide · Yarragon plumbing

No hot water? A safe checklist before you ring

Some hot water problems have simple causes. These checks are safe to do yourself. If they do not fix it, ring 03 8658 7871.

Prefer email? info@yarragonplumbing.com.au

  • Local to Yarragon
  • Licensed and insured
  • Quote before work
  • Same-day where we can

First, look for leaks

Walk around the hot water unit. If water is pooling under it or pouring from a valve, turn off the cold water valve at the unit and turn off the power or gas to it, then ring us. Do not keep using it.

Electric storage units

  • Check the switchboard. If the hot water breaker has tripped, reset it once. If it trips again, leave it off and call us.
  • If you are on an off-peak tariff and used a lot of hot water, the unit may only reheat overnight. Wait until the next morning.
  • Check that the isolating switch near the unit, if there is one, is on.

Gas storage units

  • Make sure the gas is on at the meter.
  • On LPG, check the bottles. If one is empty, the changeover valve should switch to the full one. If both are empty, order a refill.
  • Look through the viewing window to see if the pilot is lit. If it has gone out, the instructions for relighting are usually on the unit. If it will not stay lit after one attempt, call us.

Continuous flow units

  • Note any error code on the controller.
  • Check that the unit has power. They need electricity for ignition even though they burn gas.
  • On LPG, check the bottles.
  • If only one tap is cold, the problem may be the tap, not the heater.

Solar systems

  • On a run of cloudy days, make sure the booster is switched on.
  • Check the switchboard for a tripped circuit on the booster or the pump.

Heat pumps

  • Check the power supply and breaker.
  • Make sure nothing is blocking airflow around the unit.
  • Note any error lights or codes.

Lukewarm rather than cold?

If you have some hot water but not enough, the tempering valve or a heating element is the most likely culprit. That needs a plumber to test.

What not to do

Do not remove covers, adjust gas controls, touch electrical parts or try to open the relief valve while the unit is under pressure.

When you ring

Tell us the type and brand of unit, how old it is if you know, what you have checked and any error code. A photo of the label helps us bring the right parts.

Read before you ring

More guides

Burst pipe: what to do in the first ten minutesA burst pipe in your Yarragon home or on your farm? The first steps to limit damage, where to turn the water off and what to tell the plumber.Plumbing checks before you buy an older homeWhat to check in the plumbing before buying an older Yarragon home or rural property: pipes, sewer, hot water, gas, tanks and septic.Choosing a hot water system for a Gippsland homeGas, electric, solar, heat pump or continuous flow? A plain comparison for Yarragon and Gippsland homes, including LPG and tank-water properties.Finding and reading your water meter in YarragonHow to find and read your water meter in Yarragon, test for hidden leaks, and where the shut-off points are on tank-water properties.Protecting your pipes from frostHow to protect exposed water pipes, garden taps, tank lines and hot water units from frost on cold Yarragon and Gippsland mornings.Getting your gas heater ready for winterGetting gas heaters ready for a Gippsland winter: servicing, carbon monoxide warning signs, ventilation and LPG bottle checks.How to choose a plumber in YarragonWhat to look for when choosing a plumber in Yarragon: licences, insurance, compliance certificates, clear quotes and local knowledge.Looking after a septic system on a Baw Baw propertyHow to look after a septic tank and trenches on a rural property near Yarragon: what to flush, when to pump out and the warning signs.Keeping your tank water cleanPractical steps to keep tank water clean on Yarragon and Gippsland properties: gutters, first-flush diverters, filters, sludge and what to do if water smells.Tree roots and old clay sewers: what Yarragon owners should knowWhy roots get into old earthenware sewer pipes in Yarragon, the warning signs, and the choice between clearing, relining and replacing.
Free quote

Tell us about the job

Tell us what is happening and a licensed Yarragon plumber will ring you back. If water is pouring out or you can smell gas, call 03 8658 7871 instead.

03 8658 7871

We quote every job individually. We do not publish price lists, because the right answer depends on what we find.







    Need a plumber in Yarragon today?

    Talk to a licensed plumber, not a call centre. Quote first, then the work.